Installing a Brick Paver Walkway or Automatic Brick Making Machine

Using Setting up a Brick Paver Walkway or Cheapest Brick or Pavers to produce a sidewalk or outdoor patio matches a house in a way that is unrivaled. It includes a level of quality and sophistication to a home entrance that can not be accomplished with either concrete or asphalt. Brick and Pavers also come in several colors and shapes enabling special color pattern and patterns to be accomplished. In addition, installing a Brick or Paver pathway does not always require a pro. With some fundamental understanding and a reasonably basic walkway plan, a property owner is capable of undertaking such a job.

The secret to setting up a Brick or Paver Walkway is to very first effectively prepare the area where the bricks/pavers are to be installed. In addition, string lines must be strung on each side of the pathway.
As soon as the location has been dug down, 3/4" gravel stone should be laid in and tamped down tightly. The height between the tamped down sand and the stringline should equate to the density of the brick or paver.

Now that you have a steady base, place a 1" pipe or journal board the length of the walkway on either side of the walkway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready area. These strips will serve as your walkway border and assistance to keep the integrity and shape of the pathway. You can get these plastic strip borders at a lot of home improvement stores. The strips must be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.

You can then start to lay the bricks/pavers when this is done. There are read more lots of patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will once again help aac bricks keep the stability of the walkway.

Inevitably bricks/pavers will need to be cut or divided when building the sidewalk. Unless you want to purchase or lease a pricey wetsaw, I would recommend buying an easy brick/paver splitter. It is essentially a chisel with a large end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the area where you wish to break the brick. Then utilizing a hammer strike the butt end of the chisel strongly. You may require to do this a couple of times. You might also wish to flip the brick/paver over and strike the opposite of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver need to break easily. If your pathway has curves you will need to buy/rent a wetsaw.

After installing the bricks, develop up the outdoors edges with additional sand, and then shovel in the topsoil and load down firmly.
Spread stone dust over the brand-new sidewalk and sweep into the fractures. This will complete the interlocking of the bricks and help to eliminate any weed development.


In addition, setting up a Brick or Paver pathway does not always require a pro. The secret to installing a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be installed. Now that you have a stable base, position a 1" pipeline or ledger board the length of the sidewalk on either side of the sidewalk. These strips will act as your walkway border and assistance to maintain the stability and shape of the pathway. Inevitably bricks/pavers will need to be cut or divided when developing the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *